JVC GR-AX470 Prepare Camcorder, Prepare VCR, Access R.A. Edit Counter Display, Make Corrections

32EN EDITING (cont.)

REW/FF

STOP CANCEL 2

IN/OUT	3
R.A. EDIT
PLAY/PAUSE

PREPARE CAMCORDER

Insert a recorded tape and set the Power switch to “PLAY”.

PREPARE VCR

Turn the power on, insert a recordable tape and engage the AUX mode (refer to VCR’s instructions).

	Open the cover
To AUDIO	To J terminal
and VIDEO	(JLIP)
out connectors
Audio and
Video cable	Editing cable
(provided)
	(provided)
	A B	C
To AUDIO
and VIDEO IN	To Remote
connectors	PAUSE

If your TV/VCR

has the SCART To Pause-Inconnector, use

the provided cable adapter.

VCR (Recording deck)

RM-V704U/V700U (provided)

IN/OUT CANCEL VCR REC STBY ON/OFF

IN	OUT		IN	OUT
ç♣ 1 0:00:25		ç 1	0:00:25	0:01:05
2		2	0:03:18	0:03:31
3		3	0:02:33	0:02:53
4		♣ 4	0:04:11
5		5
6		6
7		7
8		8
COUNTER	0:00:25	COUNTER		0:04:11
TOTAL	0:00:00	TOTAL		0:01:13

SELECT SCENES

ACCESS R.A. EDIT COUNTER

DISPLAY

1 Press PLAY/PAUSE, then press R.A. EDIT and the counter display appears in the viewfinder and the screen of the connected TV.

REGISTER BEGINNING OF SCENE

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under IN on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under OUT on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

●The RM-V704U/V700U can be used to operate other camcorder functions as well. Point the RM-V704U/V700U at the camcorder’s remote sensor and press any of the following buttons (function apears in parentheses):

—ON/OFF (camcorder R.A. EDIT)

—IN/OUT (camcorder IN/OUT)

—CANCEL (camcorder CANCEL)

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, leave at least 15 seconds open between scenes.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing R.A.EDIT clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.