
42 EN |
|
|
|
| DETAILS | |
| I T E M S |
| N O T E S |
| ||
|
|
|
| |||
| ➪ Power |
| ❍ Perform charging where the temperature is between 10°C and 35°C | |||
| ( pg. 6) |
| (50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature | |||
|
|
| range for charging. If the environment is too cold, charging may be | |||
|
|
| incomplete. |
|
|
|
|
|
| ❍ Charging times are for a fully discharged battery pack. | |||
|
|
| ❍ Charging time varies according to the ambient temperature and the | |||
|
|
| status of the battery pack. |
|
|
|
|
|
| ❍ To avoid interference with reception, do not use the AC Adapter | |||
|
|
| near a radio. |
|
|
|
|
|
| ❍ Since the AC Adapter processes electricity internally, it becomes | |||
|
|
| warm during use. Be sure to use it only in | |||
|
|
| ❍ The following operation stops charging or discharging: | |||
|
|
| •Set the Power Switch to “ | ”, “ | ” or “ | ”. |
|
|
| •Disconnect the AC Adapter from the camcorder. | |||
|
|
| •Unplug the AC Adapter’s power cord from the AC outlet. | |||
|
|
| •Detach the battery from the camcorder. |
| ||
| ➪ Date/Time |
| ❍ The date/time cannot be stored in memory if the | |||
| Settings |
| battery runs out. Consult an authorized JVC dealer for replacement, | |||
| ( pg. 10) |
| or set the date/time as necessary before you start shooting. | |||
| ➪ Recording |
| ❍ When the Power Switch is set to “ | ” or “ | ” and the LCD | |
| ( pg. 14, 15) |
| monitor is opened at an angle of 60 degrees or more, the LCD | |||
|
|
| monitor switches on and the viewfinder switches off automatically | |||
|
|
| to save power |
|
| |
|
|
| ❍ The cassette holder cannot be opened unless a power supply is attached. | |||
|
|
| ❍ There may be a delay after you slide EJECT until the cassette holder | |||
|
|
| opens. Do not use force. |
|
|
|
|
|
| ❍ The time required to calculate the remaining tape length, and the | |||
|
|
| accuracy of the calculation, may vary according to the type of tape used. | |||
|
|
| ❍ The tape remaining time indicator is correct only if the correct tape | |||
|
|
| length has been selected ( pg. 12). |
| ||
|
|
| ❍ “TAPE END” appears when the tape reaches its end, and the power | |||
|
|
| goes off automatically if left in this condition for 5 minutes. | |||
|
|
| “TAPE END” also appears when a cassette whose tape is already at | |||
|
|
| its end is loaded. |
|
|
|
|
|
| ❍ If the Recording Start/Stop button is pressed after the Record- | |||
|
|
| Standby mode has continued for over 5 minutes, recording may not | |||
|
|
| start immediately. |
|
|
|
|
|
| ❍ While shooting, sound is not heard from the speaker | |||
|
|
| only). |
|
|
|
| ➪ TBC |
| ❍ The “TBC” indicator turns green (gray with a camcorder equipped | |||
| (Time Base |
| with a black/white viewfinder) while TBC is working. | |||
| Corrector) |
| ❍ TBC does not work during still playback and shuttle search. | |||
| ( pg. 31) |
| ❍ The “TBC” indicator turns white while TBC is not operative. | |||
|
|
| ❍ It may take a few seconds before TBC actually starts working. | |||
|
|
| ❍ The picture may be distorted if the TBC mode is activated or | |||
|
|
| deactivated at the | |||
|
|
| resumes after still playback or shuttle search. |
| ||
|
|
| ❍ If the playback picture is distorted when TBC is set to on, turn off TBC. | |||
|
|
|
|
|
|
|