JVC GR-AX860 specifications Editin G

40

REW/FF CANCEL

IN/OUT

R.A. EDIT

PLAY/PAUSE

STOP

EDITING(cont.)

PREPARE CAMCORDER

2 Insert a recorded tape and set the Power switch to “PLAY”.

PREPARE VCR

3 Turn the power on, insert a recordable tape and engage the AUX mode (refer to VCR’s instructions).

	To JLIP	To AUDIO and
		VIDEO out
		connectors
Editing cable		Audio and Video
(provided)		cable (optional)
C	A	If your TV/VCR
	B
		has the SCART
		connector, use
	To Remote	the provided
		cable adapter.
	PAUSE
To Pause-In		To AUDIO IN
		To VIDEO IN

VCR (Recording deck)

VCR REC STBY

ON/OFF

CANCEL

IN/OUT

RM-V706U (provided)

IN	OUT		IN	OUT
ç 1 0:00:25	-- : -- : --	ç 1	0:00:25	0:01:05
2		2	0:03:18	0:03:31
3		3	0:02:33	0:02:53
4		4	0:04:11	-- : -- : --
5		5
6		6
7		7
8		8
COUNTER	0:00:25	COUNTER		0:04:11
TOTAL	0:00:00	TOTAL		0:01:13

SELECT SCENES

ACCESS R.A. EDIT COUNTER DISPLAY

1 Press PLAY/PAUSE, then press R.A. EDIT and the counter display appears in the viewfinder and the screen of the connected TV.

REGISTER BEGINNING OF SCENE

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under IN on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under OUT on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

●The RM-V706U can be used to operate other camcorder functions as well. Point the RM-V706U at the camcorder’s remote sensor and press any of the following buttons (function apears in parentheses):

—ON/OFF (camcorder R.A. EDIT)

—IN/OUT (camcorder IN/OUT)

—CANCEL (camcorder CANCEL)

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, leave at least 15 seconds open between scenes.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing R.A.EDIT clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.