Tape remaining time indicator
25MIN
MIN
(Now calculating)
120MIN
119MIN
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
0MIN
(Blinking)
Start/Stop Button
EN
13
STOP RECORDING
4 Press the Recording Start/Stop Button again to stop recording.
•The camcorder
NOTES:
●When the Power Switch is set to CAMERA and the LCD monitor is opened at an angle of 45 degrees or more, the LCD monitor switches on and the viewfinder switches off automatically to save power.
●A cassette holder can’t be opened unless a power supply is attached.
●There may be a delay after you press EJECT until the holder opens. Do not use force.
●The tape remaining time is only displayed in the viewfinder as shown.
●The remaining time indicated in the viewfinder is approximate.
●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
●The tape remaining time indicator is correct only if the correct tape length has been selected (☞ pg. 8).
●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.
●If the
●If the Recording Start/Stop Button is pressed after the
5 minutes, recording may not start immediately.
●If you’re recording on a cassette from the middle (such
as when a tape is removed and
●The LENS COVER warning blinks for about 5 seconds when the camcorder is turned on when the cover is closed.
●While shooting, sound is not heard from the speaker.
