JVC GR-AXM80 manual Counter R/M Power, Tape Counter, Insert editing Indicator, Start/Stop Rew

NOTES:

Press STOP.

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

BEGIN INSERT EDITING

6 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

END INSERT EDITING

7

RESET COUNTER

Play back the tape, locate the point and press PAUSE on the camcorder or the remote control.

FIND EDIT-OUT POINT

Set the Power switch to “PLAY”.

1

2

3 Press and hold COUNTER R/M for more than

2 seconds to reset the tape counter, then press for less than 1 second and make sure “M” appears in the LCD monitor or the viewfinder.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V705U or RM-V700U remote control unit to perform this procedure.

SELECT MODE

44EN USINGREMOTECONTROLUNIT (cont.)

COUNTER R/M

POWER

	M-1:23:45	Tape Counter
				FIND EDIT-IN POINT
		Insert editing
		indicator		Press REW to go a little beyond the beginning of the
			4 scene you want to replace, press PLAY to view the
				recorded tape, and press PAUSE at exactly at the
LCD monitor or				point where the new scene should start.
viewfinder				ENGAGE INSERT EDITING MODE

START/STOP

REW

	PLAY		● When Insert Editing is performed with the LCD monitor
			fully opened, the original audio will be heard from the
	PAUSE		speaker.
	REW		● After step 5, Retake (☞ pg. 18) can be performed.
	INSERT		● The tape may stop slightly before or after the
			designated end point, and noise bars may appear.
RM-V700U		RM-V705U
	OR		Neither indicates a defect in the unit.
(optional)		(provided)	● Only video signal is recorded in the Insert Editing
			mode.