JVC GR-D252 Audio Dubbing, Insert Editing, EN Editing, To hear the dubbed sound during playback

40 EN EDITING

Audio Dubbing			● While an optional microphone is connected, the
			built-in microphone is disabled.
The audio track can be customised only when			Insert Editing
recorded in the 12-BIT and SP modes.
( pg. 25)			You can record a new scene into a previously
● Use the provided remote control.
			recorded tape, replacing a section of the original
		Microphone
			recording with minimal picture distortion at the in
		Connector
			and outpoints. The original audio remains
	Speaker		unchanged.
			● Use the provided remote control.
			NOTES:
	START/		● Before performing the following steps, make sure
	STOP		that “TIME CODE” for “CAMERA DISPLAY” and
REW	PAUSE	Stereo Microphone	“VIDEO DISPLAY” is set to “ON”.
	PLAY		( pg. 24, 28, 29)
INSERT	STOP
			● Insert Editing is not possible on a tape recorded in
	A.DUB
			the LP mode or on a blank portion of a tape.

1 Play back the tape to locate the point where editing will start, then press PAUSE (9).

2 While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” and “MIC” indicators appear.

3 Press PLAY (U), then begin “narrating”. Speak into the microphone.

●To pause dubbing, press PAUSE (9).

4 To end Audio Dubbing, press PAUSE (9), then STOP (8).

To hear the dubbed sound during playback

Set “NARRATION” to “ON” or “MIX”. (
pg. 24, 28)

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at

12-BIT, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-BIT to 16-BIT in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-BIT recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-BIT audio or a blank portion, Audio Dubbing stops.

●Audio dubbing is also possible using an optional microphone connected to the MIC connector.

1 Play back the tape, locate the Edit-Out point and press PAUSE (9). Confirm the time code at this point. (
pg. 19)

2 Press REW (3) until the Edit-In point is located, then press PAUSE (9).

3 Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 Press START/STOP to begin editing.

●Confirm the insert at the time code you checked in step 1.

●To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (8).

NOTES:

●Program AE with special effects (
pg. 36) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. (
pg. 44)