GETTING STARTED EN 7
● When charging the battery pack for the first time or after a | The Benefits Of | |
long storage period, the POWER/CHARGE lamp may not |
| |
light. In this case, remove the battery pack from the | ||
camcorder, then try charging again. | are small but have a large | |
● If the battery operation time remains extremely short even | ||
power capacity. However, | ||
after having been fully charged, the battery is worn out and | ||
when one is exposed to | ||
needs to be replaced. Please purchase a new one. | ||
cold temperatures (below | ||
● For other notes, pg. 38. | ||
10°C/50°F), its usage time | ||
|
Using The Battery Pack |
|
|
| becomes shorter and it | |||||
|
|
|
|
| may cease to function. If | ||||
Perform steps 1 – 2 in “Charging The Battery Pack”. | |||||||||
|
| this happens, place the | colder temperatures. | ||||||
Maximum continuous recording time |
|
| battery pack in your pocket |
| |||||
|
| or other warm, protected |
| ||||||
● |
|
|
|
|
| ||||
|
|
|
| place for a short time, then |
| ||||
|
|
|
|
|
| ||||
Battery pack | LCD monitor on | Viewfinder on |
|
| |||||
|
|
|
|
| itself is not cold, it should not affect performance. | ||||
1 hr. 10 min. | 1 hr. 40 min. |
| |||||||
|
| (If you’re using a heating pad, make sure the battery pack | |||||||
|
|
|
|
| |||||
2 hr. 20 min. | 3 hr. 15 min. |
|
| does not come in direct contact with it.) | |||||
|
|
|
|
| For other notes, pg. 38. | ||||
4 hr. 10 min. | 5 hr. 50 min. |
| |||||||
|
|
|
|
|
|
|
|
| |
● |
|
|
|
|
|
| Grip Adjustment |
| |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| ||
Battery pack | LCD monitor on | Viewfinder on |
|
| |||||
|
|
|
|
|
| ||||
|
|
|
|
| 1 Adjust the velcro strip. |
| |||
1 hr. 5 min. | 1 hr. 35 min. |
|
| ||||||
|
|
|
|
| 2 Pass your right hand through the loop and grasp the | ||||
2 hr. 15 min. | 3 hr. 5 min. |
| |||||||
|
| grip. |
| ||||||
|
|
|
|
|
| ||||
4 hr. | 5 hr. 30 min. |
|
| 3 Adjust your thumb and fingers through the grip to | |||||
|
|
|
|
| |||||
* Provided |
|
|
|
| easily operate the Recording Start/Stop Button, Power | ||||
NOTES: |
|
|
|
| Switch and Power Zoom Lever. Be sure to fasten the | ||||
|
|
|
|
|
|
|
| ||
GETTING STARTED
● Recording time is reduced significantly under the following conditions:
• Zoom or
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
• The White LED Light is used.
●Before extended use, it is recommended that you prepare
enough battery packs to cover 3 times the planned shooting time.
ATTENTION:
velcro strip to your preference.
Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.
Using AC Power
Connect the AC Adapter to the camcorder as shown in the illustration on page 6.
NOTES:
●The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.
●Do not allow the DC terminals of the AC Adapter to come in contact with metals, as this can result in a short circuit and cause malfunction.
●For other notes, pg. 38.
About Batteries
DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion.
WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.
