EDITING
46 EN
MasterPage: Left
The audio track can be customised only when
recorded in the 12-BIT and SP modes.
( pg. 33)
●Use the provided remote control.
1Play back the tape to locate the point where
editing will start, then press PAUSE (8).
2While holding A. DUB ( ) on the remote
control, press PAUSE (8). The “8” indicator
appears.
3Press PLAY (3), then begin “narrating”.
Speak into the microphone.
●To pause dubbing, press PAUSE (8).
4To end Audio Dubbing, press PAUSE (8),
then STOP (7).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”.
( pg. 32, 36)
NOTES:
●Sound is not heard from the speaker during Audio
Dubbing.
●When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
●If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
●If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the
TV, or turn down the TV’s volume.
●If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-BIT recording began.
●During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes
recorded in 16-BIT audio or a blank portion, Audio
Dubbing stops.
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
●Use the provided remote control.
NOTES:
●Before performing the following steps, make sure
that “TIME CODE” in both Recording and
Playback Menus is set to “ON”. ( pg. 32, 35, 36)
●Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1Play back the tape, locate the Edit-Out point
and press PAUSE (8). Confirm the time code at
this point. ( pg. 22)
2Press REW (1) until the Edit-In point is
located, then press PAUSE (8).
3Press and hold INSERT ( ) on the remote
control, then press PAUSE (8). The “8”
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in
step 1.
●To pause editing, press START/STOP. Press it
again to resume editing.
5To end Insert Editing, press START/STOP,
then STOP (7) on the remote control.
NOTES:
●Program AE, Effects and Shutter Effects
( pg. 42) can be used to spice up the scenes
being edited during Insert Editing.
●During Insert Editing, the date and time
information changes.
●If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
●During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. ( pg. 50)
Audio Dubbing
PAUSE
PLAY
A.DUB
STOP
REW
INSERT
START/
STOP
Speaker
Stereo Microphone
Insert Editing
GR-D370AH_EN.book Page 46 Monday, April 17, 2006 2:24 PM