|
| Warning Indications |
| The memory card cannot be removed from |
| |
| the camcorder. |
|
|
●The viewfinder is pulled out and “PRIORITY” is
set to “FINDER”.
HPush the viewfinder back in or set “PRIORITY” to “LCD”. ( pg. 20, 32, 34)
●The LCD monitor’s brightness setting is too dark. HAdjust the brightness of the LCD monitor.
HIf the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 20)
An error indication (01 – 04 or 06) appears.●A malfunction of some kind has occurred. In this case the camcorder’s functions become unusable. ( pg. 50)
The remote control does not work.●“REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. ( pg. 32, 34)
●The remote control does not point at the remote
sensor.
HPoint at the remote sensor. ( pg. 25)
●The remote control batteries are exhausted.
Remaining power level
High | Exhausted |
As the battery power comes close to nil, the battery remaining power indicator blinks. When the battery power is exhausted, power turns off automatically.
●Appears if a tape is loaded. ( pg. 18)
●Blinks when no tape is loaded.( pg. 18)
CHECK TAPE’S ERASE PROTECTION TABAppears when the erase protection tab is set to “SAVE” while the Power Switch is set to “REC” and the VIDEO/MEMORY Switch is set to “VIDEO”. ( pg. 16)
USE CLEANING CASSETTEAppears if dirt is detected on the heads during recording. Use an optional cleaning cassette. ( pg. 53)
CONDENSATION, OPERATIONPAUSED PLEASE WAITAppears if condensation occurs. When this indication is displayed, wait more than 1 hour until condensation disappears.
Appears if a tape is not loaded when the Recording Start/Stop Button or SNAPSHOT Button is pressed while the Power Switch is set to “REC” and the VIDEO/MEMORY Switch is set to “VIDEO”.
TAPE ENDAppears when the tape ends during recording or playback.
SET DATE/TIME!●Appears when the date/time is not set. ( pg. 16)
●The