28 EN EDITING

Dubbing To Or From A Video Unit

To use this camcorder as a player

1 Make sure all units are turned off.

Equipped With A DV Connector (Digital

2 Connect this camcorder to a video unit equipped with

Dubbing)

a DV input connector using a DV cable as shown in the

illustration.

It is also possible to copy recorded scenes from the

3 Set this camcorder’s Power Switch to “PLAY” while

camcorder onto another video unit equipped with a DV

pressing down the Lock Button located on the switch.

connector. Since a digital signal is sent, there is little if

4 Turn on the video unit’s power.

any image or sound deterioration.

5 Insert the source cassette in this camcorder.

 

 

6 Insert the recording cassette in the video unit.

 

7 Press 4/9 on this camcorder to start playback of the

 

source cassette.

 

8 At the point you want to start dubbing, engage the

 

video unit’s Record mode.

 

9 To pause dubbing, engage the video unit’s Record-

 

Pause mode and press 4/9 on this camcorder.

 

10 Repeat steps 7 – 9 for additional editing. Stop the

 

video unit and camcorder.

To DV IN/OUT

NOTES:

Core filter DV cable (optional)

To DV IN/OUT

Video unit equipped with DV connector

●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 7)

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 8. If this occurs, turn off the power and make connections again.

●If “Playback Zoom” ( pg. 16) or “Playback Special Effects” ( pg. 16) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV connector.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

To use this camcorder as a recorder

1)Perform steps 1 to 3 in “To use this camcorder as a player”.

2)Set “REC MODE” to “SP” or “LP”. ( pg. 18, 19)

3)Insert the recording cassette in this camcorder.

4)Press the Recording Start/Stop Button to engage the Record-Pause mode.

● The “ DV. IN ” indication appears on the screen.

5)Press the Recording Start/Stop Button to start recording. The T indication rotates.

6)Press the Recording Start/Stop Button again to stop recording. The T indication stops rotating.

NOTES:

●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 18, 21)

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 19)