JVC GR-D750US Basic Recording, Tape Remaining Time, Quick Review, 16 EN VIDEO RECORDING, START/STOP, START/STOP, Approximate recording time, 1) Press QUICK REVIEW during

16 EN VIDEO RECORDING

Basic Recording			Tape Remaining Time
Basic Recording			Approximate tape
NOTE:			Approximate tape
NOTE:			remaining time appears on
Before continuing, perform the procedures listed			the display. “– – – min”
below:			means the camcorder is
● Power ( pg. 12)			calculating the remaining
● Loading A Cassette ( pg. 15)			time. When the remaining time reaches
● Remove the lens cap. ( pg. 11)			2 minutes, the indication starts blinking.
● Open the LCD monitor fully.			● The time required to calculate and display the
● Select videos at 4:3 size or 16:9 (wide) size.			remaining tape length, and the accuracy of the
● Select videos at 4:3 size or 16:9 (wide) size.			calculation, may vary according to the type of
( pg. 15)			calculation, may vary according to the type of
( pg. 15)			tape used.
			tape used.
	Zoom Lever		Quick Review
			Enables to check the end of the last recording.
			1) Press QUICK REVIEW during
			the Recording-Standby mode.
	Lock Button		2) Tape is rewound for about
	Lock Button		several seconds and played back
			several seconds and played back
	Recording Start/Stop		automatically, then pauses in the
	Recording Start/Stop		Recording-Standby mode for the next shot.
	Button		Recording-Standby mode for the next shot.
	Button		● Distortion may occur at start of playback. This is
1 Set the Power Switch to “REC” while			● Distortion may occur at start of playback. This is
			normal.
			● Slide the Power Zoom lever repeatedly to
pressing down the Lock Button located on the			● Slide the Power Zoom lever repeatedly to
pressing down the Lock Button located on the			change the sound to on/off.
switch.			change the sound to on/off.
switch.
2 Press START/STOP button to start
recording. “REC” appears on the display while
recording is in progress. To stop recording,
press START/STOP again.
Approximate recording time
Tape	Recording mode
Tape	SP	LP
	SP	LP
30 min.	30 min.	45 min.
60 min.	60 min.	90 min.
80 min.	80 min.	120 min.

NOTES:

●If the Record-Standby mode continues for

5 minutes and no operation is performed, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewﬁnder again or close and re-open the LCD monitor.

●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to “Recording From The Middle Of A Tape” ( pg. 18).

●To record in LP (Long Play) mode, pg. 24.