5 Select the number of prints by rotating the MENU/ VOLUME wheel % and press it.
Repeat steps 3 through 5 for the desired number of prints.
•The number of prints can be set up to 15.
•To correct the number of prints, select the image again and change the number.
6 Rotate the MENU/VOLUME wheel % to select
“RETURN” and press it. Selection is complete. “SAVE?” appears.
•If you did not change any settings in step 3 through 5, the Menu Screen reappears.
7 Rotate the MENU/VOLUME wheel % to select
“EXECUTE”, then press it to save the setting you have just made.
•To cancel selection, rotate the MENU/VOLUME wheel % to select “CANCEL” and press it.
To Reset The No. Of Prints . . .
..... select “RESET” in step 4 of “TO PRINT ALL STILL
IMAGES (ONE PRINT FOR EACH)” on pg. 21. The number of prints is reset to 0 for all still images.
CAUTION
While performing the above, never disconnect power, as this may cause the memory to be corrupted. For safety, all buttons including the Power Switch u are disabled in step 6.
NOTES:
●“BATTERY LOW” appears if the battery remaining power is too low.
●If you load a memory card already set as shown above in a printer compatible with DPOF, it will make prints of the selected still images automatically.
●To print images recorded on a tape, first dub them to a memory card ( pg. 21).
3 Rotate the MENU/VOLUME wheel % to select “EXECUTE”, then press it. The new folder (such as “101JVCGR”) will be made and the file name of the next shot starts from DVC00001.
Folder and File names
Each time shooting takes place, a file name is made using a number which is larger by one than the largest number of the file names which are in use. Even if you delete an image file with a number in the middle of range, the number will not be used for a new shot; a gap will remain in the numerical sequence. If the file name reaches DVC09999, a new folder (such as “101JVCGR”) will be made and the file name will start again from DVC00001.
Initialising A Memory Card
You can initialise a memory card anytime.
After initialising, all files and data stored on the memory card, including those which have been protected, are cleared.
1 Perform step 1 of “Making A New Folder”.
2 Press the MENU/VOLUME wheel % in. The Menu Screen appears. Rotate the MENU/VOLUME wheel % to select “FORMAT” and press it. The FORMAT Screen appears.
3 Rotate the MENU/VOLUME wheel % to select “EXECUTE” and press it. The memory card is initialised. When initialisation is finished, “NO IMAGES STORED” appears.
•To cancel initialisation, rotate the MENU/VOLUME wheel % to select “RETURN” and press it.
Making A New Folder | CAUTION |
New still pictures you are going to take can be separated from previously shot pictures by resetting the file name to DVC00001; these new pictures will be stored in a new folder.
1 Set the VIDEO/MEMORY Switch 4 to “MEMORY”, then set the Power Switch u to “PLAY” while pressing down the Lock Button y located on the switch.
•A stored file is displayed.
2 Press the MENU/VOLUME wheel % in. The Menu Screen appears. Rotate the MENU/VOLUME wheel % to select “NO. RESET”, then press it. The NO. RESET Screen appears.
Do not perform any other operation (such as turning off the camcorder) during initialisation. Also, be sure to use the provided AC Adapter, as the memory card may be corrupted if the battery becomes exhausted during initialisation. If the memory card becomes corrupted initialise it.
EN
