Connect the AC Adapter to the camcorder. Connect the Power Cord to the AC Adapter.

 

 

 

 

 

GETTING STARTED

EN 13

How To Attach The Core Filter

 

 

 

 

 

 

 

 

 

Power

 

 

Attach the core filters to the cables. The core

 

 

 

 

 

 

 

 

This camcorder’s 2-way power supply system

filter reduces interference.

 

 

lets you choose the most appropriate source of

1 Release the stoppers on both ends of the

 

 

power. Do not use provided power supply units

core filter.

 

with other equipment.

Charging The Battery Pack

Stopper

2 Run the cable through the core filter, leaving

BATT. RELEASE

Battery pack

Open the cover.

approx. 3 cm of cable between the cable plug and the core filter.

Wind the cable once around the outside of the core filter as shown in the illustration.

Core filter

3 cm

Wind once.

3 Close the core filter until it clicks shut.

 

To

 

DC connector

Arrow

 

Battery pack mount

mark

Power switch

AC Adapter

 

POWER/CHARGE

 

lamp

 

Power cord

 

 

To AC outlet

NOTES:

●Take care not to damage the cable.

●When connecting a cable, attach the end with the core filter to the camcorder.

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.

3 Slide the battery pack to the right until it locks in place b.

4

5

6 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

CONTINUED ON NEXT PAGE