Connect the AC Adapter to the camcorder.

 

 

 

 

 

GETTING STARTED

EN 13

How To Attach The Core Filter

 

 

 

 

 

 

 

 

 

Power

 

 

Attach the core filters to the cables. The core

 

 

 

 

 

 

 

 

This camcorder’s 2-way power supply system

filter reduces interference.

 

 

lets you choose the most appropriate source of

1 Release the stoppers on both ends of the

 

 

power. Do not use provided power supply units

core filter.

 

with other equipment.

Charging The Battery Pack

Stopper

2 Run the cable through the core filter, leaving

BATT. RELEASE

Battery pack

Open the cover.

approx. 3 cm of cable between the cable plug and the core filter.

Wind the cable once around the outside of the core filter as shown in the illustration.

Core filter

3 cm

Wind once.

3 Close the core filter until it clicks shut.

 

To

 

DC connector

Arrow

 

Battery pack mount

mark

Power switch

AC Adapter

 

(ex. AP-V14E)

POWER/CHARGE

 

lamp

 

Power cord

 

 

To AC outlet

NOTES:

●Take care not to damage the cable.

●When connecting a cable, attach the end with the core filter to the camcorder.

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.

3 Slide the battery pack to the right until it locks in place b.

4

5 Connect the Power Cord to the AC Adapter (AP-V14E only).

6 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

CONTINUED ON NEXT PAGE