56 EN EDITING

To hear the dubbed sound during playback

 

 

Insert Editing

Set “NARRATION” to “ON” or “MIX”.

 

 

( pg. 37, 41)

 

 

 

You can record a new scene into a previously

NOTES:

recorded tape, replacing a section of the original

● Sound is not heard from the speaker during Audio

recording with minimal picture distortion at the in

Dubbing.

and out points. The original audio remains

● When editing onto a tape that was recorded at

unchanged.

12-BIT, the old and new soundtracks are recorded

● Use the provided remote control.

separately.

NOTES:

● If you dub onto a blank space on the tape, the

sound may be disrupted. Make sure you only edit

● Before performing the following steps, make sure

recorded areas.

 

that “TIME CODE” is set to “ON”. ( pg. 37, 42)

● If feedback or howling occurs during TV playback,

● Insert Editing is not possible on a tape recorded in

move the camcorder’s microphone away from the

 

the LP mode or on a blank portion of a tape.

TV, or turn down the TV’s volume.

1 Play back the tape, locate the Edit-Out point

● If you change from 12-BIT to 16-BIT in mid-

recording and then use the tape for Audio

and press PAUSE (9). Confirm the time code at

Dubbing, it is not effective from the point where

this point. ( pg. 21)

16-BIT recording began.

2 Press REW (3) until the Edit-In point is

● During Audio Dubbing, when the tape moves to

located, then press PAUSE (9).

scenes recorded in the LP mode, scenes

3 Press and hold INSERT (I) on the remote

recorded in 16-BIT audio or a blank portion, Audio

Dubbing stops.

control, then press PAUSE (9). The “9I”

● Audio dubbing is also possible using an optional

indicator and the Time Code (min.:sec.) appear

microphone connected to the MIC connector.

and the camcorder enters Insert-Pause mode.

● While an optional microphone is connected, the

4 Press START/STOP to begin editing.

built-in microphone is disabled.

● Confirm the insert at the time code you checked in

● To perform Audio Dubbing with a video unit

 

step 1.

connected to the camcorder’s AV connector, first

 

● To pause editing, press START/STOP. Press it

set “S/AV INPUT” to “ON” in VIDEO Menu.

 

again to resume editing.

( pg. 37, 42)

 

5 To end Insert Editing, press START/STOP,

The “AUX” indication appears instead of “MIC”.

 

then STOP (8).

 

NOTES:

 

● Program AE with special effects ( pg. 48) can

 

 

be used to spice up the scenes being edited

 

 

during Insert Editing.

 

● During Insert Editing, the date and time

 

 

information changes.

 

● If you perform Insert Editing onto a blank space on

 

 

the tape, the audio and video may be disrupted.

 

 

Make sure you only edit recorded areas.

 

● During Insert Editing, when the tape moves to

 

 

scenes recorded in the LP mode or a blank

 

 

portion, Insert Editing stops. ( pg. 60)