EDITING EN 55

When connecting the camcorder to a PC using a DV cable, make sure to follow the procedure below. Connecting the cable incorrectly may cause malfunctions to the camcorder and/or the PC.

●Connect the DV cable first to the PC, and then to the camcorder.

●Connect the DV cable (plugs) correctly according to the shape of the DV connector.

[A] Using USB cable

It is possible to do the following things:

●Transfer still images stored on a memory card to a PC.

●Transfer still/moving images recorded on a tape to a PC.

●The system may not work properly depending on the PC or capture board you are using.

“USB” appears on the LCD monitor while the PC is accessing data in the camcorder or the camcorder is transferring a file to the PC.

NEVER disconnect the USB cable while “USB” is displayed on the LCD monitor since this can result in product damage.

Audio Dubbing

The audio track can be customised only when recorded in the 12-BIT and SP modes.

( pg. 38)

●Use the provided remote control.

Microphone Connector

[B] Using DV cable

It is also possible to transfer still/moving images to a PC with a DV connector by using the provided software, software equipped with the PC or commercially available software.

If you are using a Windows® XP, you can use Windows® Messenger to conduct video conferences over the Internet, using a camcorder. For details, refer to the help for the Windows® Messenger.

NOTES:

●Refer to “SOFTWARE INSTALLATION AND PC CONNECTION GUIDE” for the bundled software and drivers.

●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 15)

●Never connect the USB cable and the DV cable simultaneously to the camcorder. Connect only the cable you wish to use to the camcorder.

●When using a DV cable, be sure to use the optional JVC VC-VDV206U or VC-VDV204U DV cable depending on the type of DV connector (4 or 6 pins) on the PC.

●If the PC connected to the camcorder via the USB cable is not powered, the camcorder does not enter the USB mode.

●The date/time information cannot be captured into the PC.

●Refer to the instruction manuals of the PC and Software.

●The still images can also be transferred to a PC with a DV connector-equipped capture board.

Speaker

 

START/

 

 

STOP

Stereo Microphone

 

PAUSE

 

REW

PLAY

 

INSERT

STOP

 

 

A.DUB

 

1 Play back the tape to locate the point where editing will start, then press PAUSE (9).

2 While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” and “MIC” indicators appear.

3 Press PLAY (U), then begin “narrating”. Speak into the microphone.

●To pause dubbing, press PAUSE (9).

4 To end Audio Dubbing, press PAUSE (9), then STOP (8).

CONTINUED ON NEXT PAGE