10 EN | GETTING STARTED (cont.) |
Power
Zoom Lever
Recording
Start/Stop button
Power Switch
Dioptre
Adjustment Control
PAUSE
Grip Adjustment
1
2 Pass your right hand through the loop and grasp the grip.
3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Viewfinder Adjustment
1 Set the Power Switch to “ | ” or “ | ” |
AUTO | MANUAL |
|
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the indications in the viewfinder are clearly focused.
| Shoulder Strap Attachment |
| 1 Make sure the battery pack is removed. Following |
2 | the illustration, thread the strap through the eyelet 1, |
then fold it back and thread it through the buckle 2. | |
| Repeat the procedure to attach the other end of the |
1 | strap to the other eyelet 3 located under the Grip |
Strap . Confirm the strap is not twisted. |
3
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.
1 To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.
