JVC GR-DVL257 54 EN, To while pressing down the Lock Button, To DV Core filter Lock Button

54 EN

VIDEO/DSC Switch (GR-DVL557/DVL357only)

DUBBING (cont.)

Dubbing From A Video Unit Equipped With A DV Connector (Digital Dubbing)

To DV IN

Core filter

Lock Button

			OFF
		Y
	A
P	L

[To use this camcorder as a recorder: GR-DVL557/DVL357/DVL257 only]

1 Make sure all units are turned off. Connect the camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.

2 Set “REC MODE” to “SP” or “LP” in the Menu Screen depending on your preference (
pg. 50).

3 Set the VIDEO/DSC Switch to “VIDEO” (GR- DVL557/DVL357 only), then turn the Power Switch

to “ ” while pressing down the Lock Button

DV cable
(optional)	Power Switch

Core filter

To DV OUT

Video unit equipped with DV output connector

NOTES:

located on the switch. Turn on the video unit’s power and insert the appropriate cassettes in the camcorder and the video unit.

4 Press the Recording Start/Stop Button on the camcorder to engage the Record-Pause mode.

“DV. IN ” appears on the screen.

5 Engage the video unit’s Play mode, then engage the Still Playback mode when you have found a spot just before the edit-in point.

6 Press the Recording Start/Stop Button on the

camcorder to engage the Record mode. rotates on the screen. Engage the video unit’s Play mode.

7 To stop dubbing, press the Recording Star/Stop Button

on the camcorder so that stops rotating, then engage the video unit’s Stop mode.

8 Repeat steps 5 through 7 for additional editing.

●It is recommended to use the AC Adapter as the power supply instead of the battery pack (
pg. 9).

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn off the power and make connections again.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting (
pg. 47).

●During Digital Dubbing, no signals are output from the video or audio connectors.