44 EN
1
2
3
4
5
6
7
8
IN
0:00:25
0:03:18
0:02:33
0:04:11
0:04:11
0:01:13
OUT
0:01:05
0:03:31
0:02:53
--:--:--
COUNTER
TOTAL
1
2
3
4
5
6
7
8
IN
0:00:25
0:00:25
0:00:00
OUT
--:--:--
COUNTER
TOTAL
SELECT SCENES
4

START SOURCE PLAYBACK

Press PLAY, then press ON/OFF on the remote
control. Make sure to point the remote control at the
camcorder’s remote sensor.
•The R.A. Edit counter display appears.
5

REGISTER BEGINNING OF SCENE

Press REW or FF to locate the beginning of the scene
you want, then press IN/OUT to register that point.
•The data appears under “IN” on the display.
6

REGISTER END OF SCENE

Press REW or FF to locate the end of the scene and
press IN/OUT to register it.
•The data appears under “OUT” on the display.
•The total time of the registered scene(s) is displayed
at the bottom of the screen.
7

REGISTER ADDITIONAL SCENES

Repeat steps 5 and 6 for each additional scene
(as many as 8).
8

MAKE CORRECTIONS (IF NECESSARY)

Press CANCEL during steps 5 and 6 to erase the most
recently registered point.
NOTES:
●

There must be at least one second between an in-point

and its corresponding out-point.

●

To ensure correct operation, there should be at least

15 seconds between an out-point and the next in-point.

●

Blank portions of a tape cannot be registered as in-points

or out-points.

●

If it takes more than 5 minutes to search for an in-point,

the VCR’s Record-Pause mode is cancelled and editing

does not take place.

●

Pressing ON/OFF clears all in- and out-points from

memory.

●

Leave a small margin for error around each in-point to

ensure the scene is recorded in its entirety.

●

Turning off the camcorder’s power erases all registered

in- and out-points.

USING THE REMOTE CONTROL UNIT
(cont.)
RM-V700U (provided with GR-FX40,
optional for GR-FX30/FX10)
Remote sensor
Power Switch
REW
PLAY
IN/OUT
FF
PAUSE
ON/OFF
CANCEL