42 EN | USING THE REMOTE CONTROL UNIT (cont.) |
Power Switch
COUNTER R/M Button
Display
w
|
| Insert editing |
|
| |
|
| indicator |
M– 0 : 1 2 : 3 4 |
| Tape Counter |
|
Remote sensor
START/STOP 
REW
INSERT
PLAY
PAUSE 
STOP
Insert Editing
You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and
NOTE:
Use the remote control unit to perform this procedure.
1
2
3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press it again for less than 1 second so that “M” appears.
4 Press REW (2) to go a little beyond the beginning of
the scene you want to replace, press PLAY (4) to view the recorded tape, and press PAUSE (6) exactly at the
5 Press and hold INSERT (w), and without releasing INSERT (w), press and release PAUSE (6). The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.
6 To begin Insert Editing, press START/STOP. When the counter reaches “0:00:00”, editing stops automati- cally and the camcorder enters the
7 To end Insert Editing, press STOP (5).
NOTES:
●During Insert Editing, the original audio will be heard from the speaker.
●After step 5, Retake ( pg. 19) can be performed.
●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.
●Only the video signal is recorded in the Insert Editing mode.
●If Programme AE ( pg. 23) is set during Insert Editing, press and hold P. AE for more than 1 second.
OR | ||
(provided with | (optional) | |
|
|
|
SXM46EA only) |
|
|
