JVC GR-SXM530 specifications 56 EN

56 EN TROUBLESHOOTING (cont.)

When “VIDEO” is selected (the DSC Lamp is not lit):

SYMPTOM

RECORDING

Recording cannot be performed.

POSSIBLE CAUSE(S)

●Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable

tabs. If the tab has been removed, cover the hole with adhesive tape (
pg. 15).

●If “DSC” is selected (the DSC Lamp is lit), it is not possible to record onto the tape. Press REFRESH for approx. 1 second to select “VIDEO” (the DSC Lamp is not lit).

Recording does not start.	● The camcorder Power Switch has not been set to “ “ or “ ”
	( pg. 18).
Animation or Time-Lapse is not	● Before recording in the Animation mode at the very beginning
available.	of a tape, set the camcorder to the Recording mode for about
	5 seconds, so that the tape runs smoothly. Using the Fade-in
	function at this point is a good way to begin an animated
	program ( pg. 48).
PLAYBACK
The tape is running, but there is no	● The TV has not been set to its VIDEO mode or channel.
playback picture.	● If A/V connection is used, the TV’s VIDEO/TV Switch has not
	been set to VIDEO.
Playback cannot be performed.	● If “DSC” is selected (the DSC Lamp is lit), it is not possible to
	play back a tape. Press REFRESH for approx. 1 second to select
	“VIDEO” (the DSC Lamp is not lit).
Playback picture is blurred or	● The video heads are dirty or worn out. Consult your nearest
interrupted.	JVC dealer for head cleaning or replacement.
The counter indication is blurred during	● This is normal.
Still playback.
TAPE TRANSPORT
The tape stops during fast-forward or	● The Counter Memory Function has been activated ( pg. 23).
rewind.
Rewinding or fast-forwarding cannot be	● The tape is already fully wound on one reel or the other.
performed.
OTHER
The picture is blurred in the Quick	● This is normal while recording in the EP mode. Some noise
Review or Retake mode.	may be present while recording in the SP mode ( pg. 14).
The date and time displays	● If you remove the power source from the camcorder while the
disappear.	power is on, all settings and selections are erased. Make sure to
	turn the camcorder’s power off before disconnecting the power
	source.
The wrong date and time are displayed/	● If you have not performed Date/Time Setting ( pg. 11), the
recorded.	date and time are not displayed/recorded correctly. Be sure that
	Date/Time setting is carried out.
The tape will not eject.	● The battery pack is running low.
	● If the LCD monitor is not open over 60 degrees, EJECT switch
	does not function.