| EN59 | |
I T E M S | N O T E S |
|
|
|
|
➪ VIDEO | ❍ When the Power Switch is set to “ ” or “ ” and the LCD | |
RECORDING | monitor is opened at an angle of 60 degrees or more, the LCD | |
( pg. 18, 19) | monitor switches on and the viewfinder switches off automatically | |
| to save power. | |
❍The cassette holder cannot be opened unless a power supply is attached.
❍There may be a delay after you slide EJECT until the cassette holder opens. Do not use force.
❍The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
❍The tape remaining time indicator is correct only if the correct tape length has been selected ( pg. 14).
❍“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at its end is loaded.
❍If the Recording Start/Stop button is pressed after the Record- Standby mode has continued for over 5 minutes, recording may not start immediately.
❍While shooting, sound is not heard from the speaker.
➪ TBC | ❍ The “TBC” indicator turns green (gray with a camcorder equipped |
(Time Base | with a black/white viewfinder) while TBC is working. |
Corrector) | ❍ TBC does not work during still playback and shuttle search. |
( pg. 23) | ❍ The “TBC” indicator turns white while TBC is not operative. |
| ❍ It may take a few seconds before TBC actually starts working. |
| ❍ The picture may be distorted if the TBC mode is activated or |
| deactivated at the |
| resumes after still playback or shuttle search. |
| ❍ If the playback picture is distorted when TBC is set to on, turn off |
| TBC. |
