52EN

USING THE REMOTE CONTROL UNIT (cont.)

REFRESH Button

COUNTER R/M Button

DSC Lamp

Power Switch

Display

w

 

 

 

Insert editing

 

 

 

 

 

 

indicator

M– 0 : 1 2 : 3 4

 

 

Tape Counter

 

 

 

e4

 

Audio dubbing

 

 

M– 0 : 0 5 : 2 0

 

indicator

 

 

During Audio

 

 

Dubbing

Remote sensor

Microphone

START/STOP

PLAYFF

REWPAUSE

STOPA.DUB INSERT

Insert Editing (VIDEO)

You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the remote control unit to perform this procedure.

1 Set the Power Switch to “”. If the DSC Lamp is lit, press REFRESH for approx. 1 second to select “VIDEO”.

2 Play back the tape, locate the Edit-Out point and press PAUSE (6).

3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press it again for less than 1 second so that “M” appears.

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the Edit-In point where the new scene should start.

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE on the Remote Control. The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

6 To begin Insert Editing, press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

7 To end Insert Editing, press STOP.

NOTES:

●During Insert Editing, the original audio will be heard from the speaker.●After step 5, Retake ( pg. 21) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only the video signal is recorded in the Insert Editing mode.