GettingIntroductionstarted
This page is for when operating your TV using the remote control of this product.
Operating the TV using the remote control
Setting the manufacturer's code
1 Slide the remote control mode selector to the TV side.
2 Keep pressing down 
TV.
NOTE
Keep pressing down 
TV until Step 4 is complete.
3 Press ENTER.
4 Press number buttons (1-9, 0).
Ex.:
For a Hitachi TV: Press 0, then 7.
For a Toshiba TV: Press 2, then 9.
If there are more than one manufacturer’s codes, try them in turn and select the one that causes the product to work properly.
Manufacturer | Code | Manufacturer | Code | ||
JVC | 01 | Nordmende | 13, 14, 18, | ||
26 | – 28 | ||||
|
|
| |||
Akai | 02, 05 | Okano | 09 |
| |
Blaupunkt | 03 | Orion | 15 |
| |
Daewoo | 10, 31, 32 | Panasonic | 16, 17 | ||
Fenner | 04, 31, 32 | Philips | 10 |
| |
Fisher | 05 | Saba | 13, 14, 18, | ||
26 | – 28 | ||||
|
|
| |||
Grundig | 06 | Sanyo | 05 |
| |
Hitachi | 07, 08 | Schneider | 02, 05 | ||
09 | Sharp | 20 |
| ||
Irradio | 02, 05 | Sony | 21 | – 25 | |
Magnavox | 10 | Telefunken | 13, 14, 18, | ||
26 | – 28 | ||||
|
|
| |||
Mitsubishi | 11, 33 | Thomson | 13, 14, 18, | ||
26 | – 28, 30 | ||||
|
|
| |||
Miver | 03 | Toshiba | 29 |
| |
Nokia | 12, 34 |
|
|
| |
NOTE
Manufacturer’s codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above.
5 Release 
TV.
For TV operation
Operate the remote control by pointing it towards the TV.
Turn ON/OFF the power.
Change channels.
Adjust volume.
9 | Select channels. |
100+
*1
Alternates between the previously selected channel and the current channel.
Switch TV and video input.
*1 Make sure to slide the remote control mode selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the manufacturer's code setting again.
7
