Getting Started

Opening the Terminal Cover (SD Card Cover)

oTo open

A Open the LCD monitor.

BSlide down the terminal cover lock and slide the cover aside. C Lift the cover slowly.

oTo close

Leave the LCD monitor open first.

AFlip down the cover slowly while making sure the gray waterproof seal fits into the opening at the terminals.

BPress the entire cover against the camcorder with equal force and firmly attach the cover completely.

C Slide the cover until it clicks into place.

The cover is not properly closed if the red mark on the terminal cover lock is visible.

Caution :

0Ensure that the terminal cover and the gray waterproof seal are not damaged and that there are no foreign materials (such as hair, lint, sand or dust) adhered on the cover.

0Stop using the unit underwater if there are damages to the cover, etc. and consult your JVC dealer or the nearest JVC service center.

0Do not apply excessive force when opening/closing the terminal cover.

Charging

This unit is equipped with a built-in battery.

Open the connector cover, and connect the AC adapter for charging as shown in the figure.

Caution :

0The built-in battery is not charged at the time of purchase.

0At the time of purchase or in case of the battery is not used for a long period of time, the charging time will be longer than usual. The camera does not turn on if the remaining battery power is low. In this case, charge the battery for more than 20 minutes before turning on the power.

0Charging time: Approx. 4 h 40 m (when charging at 25 ℃ (77 °F))

0The battery cannot be charged outside the room temperature range of 10°C to 35°C (50°F to 95°F). The CHARGE lamp does not light up when the battery is not being charged. If the temperature increases or decreases during charging, the CHARGE lamp will blink slowly and charging will stop. In this case, remove the AC adapter, press the Reset button and wait until the room temperature is within the above stated range before charging again.

0You can record or play back videos during charging. (However, the charging time will be longer than usual. In addition, the remaining battery power may decrease according to conditions.) If the internal temperature rises when using the unit, stop the charging temporarily. (The CHARGE lamp goes off.)

0If malfunctions (such as overvoltage) occur, charging will stop. In these cases, CHARGE lamp blinks quickly as a notification.

0During charging, the Picon on the screen changes to Oto indicate that charging is in progress. (when the provided AC adapter is used)

0When the recording time becomes extremely short even when the battery is fully charged, the battery needs to be replaced. For details on replacing the built-in battery (subject to a fee), consult the nearest JVC service center.

Caution :

0There are certain specifications for a USB rechargeable device. To charge, use a device with the output voltage of 5 V/1 A or more.

0Depending on the specification of your charging device and the thickness and length of an USB cable used to connect to this unit, the charging time may be longer than usual, or it may not even start.

0We shall not be held liable for malfunctions that are due to using non- standard device or a device with poor quality.

5