JVC VN-H37U, H57U operation manual Set values ON, OFF Status No Recording , Recording, Be changed

No.		Item		Description
③	Record Status		[Set values	: ON, OFF]
			[Status	: No Recording, Recording]
			This is only enabled when the SD card status is "Use" and the format status is
			"Format complete".
			When recording, the status changes to [Recording]. When recording is stopped,
			the status changes to [Stopped]. When only alarm recording is selected, the
			status is [Stopped] at times other than when the alarm is engaged.
			Check "ON" and check one of the available settings in "Recording image quality
			settings" to begin continuous-loop recording to the SD card with the selected
			recording quality.
			Starts continuous-loop recording to the SD card with the selected recording
			quality.
			If you push [OK] when the encoding setting has not been set, the "Select an
			encoding setting." dialog is displayed and recording does not start.
			Select "OFF" and click the [OK] button to stop recording.
④	Recording		To change the recording image quality, select "OFF" for ③ Record Status, push
	image quality		the [OK] button to stop recording, and then configure settings.
			If you push [OK] when the recording image quality has not been set, the "Set the
			recording mode." dialog is displayed and recording does not start.
			You can select either "Constant", "Alarm", or both settings.
			Memo：
			z When the record status is "ON", the setting for Recording image quality cannot
			be changed.
		Constant	Constantly records to the SD card.
		Alarm	SD card recording is performed when conditions set for the alarm setting items
			are met. The alarm event recording interval for when an alarm is triggered is from
			60 seconds before the trigger (pre-trigger) to 60 seconds after the trigger
			(post-trigger), for a total of 120 seconds.
			Memo：
			z Even if another trigger is detected within 60 seconds of the first trigger, it will
			not appear in the event list.
			z If another trigger is detected during alarm recording, recording is extended 60
			seconds from the original end point.
			z If less than 60 seconds have passed since video recording was initially started,
			the pre-trigger time will be less than 60 seconds.
				* The [Set values] in bold letters are factory defaults

Alarm recording-related setting items are displayed when "Alarm" is selected.

15