Quick Setup
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you need to begin using your new monitor right away. If you have questions, or for more detailed information on any of these steps, please consult other sections of this manual.
Step 1 – The Remote Control
Before you can operate your remote control, you first need to install the batteries (included).
Lift and pull the latch on the back of the remote control to open. Insert two batteries (included) carefully noting the “+” and
When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or cable box/satellite receiver may have to be reset. See pages 25 - 28.
Key Feature Buttons | MUTING | OK |
The four key feature buttons at the center of the remote can | CH + | |
|
| |
be used for basic operation of the monitor. The right and |
|
|
left buttons will turn the volume up or down. These buttons | VOL | VOL |
are also marked with four arrows and are used with JVC’s | – | + |
|
| |
onscreen menu system. To use the onscreen menus, press the |
|
|
MENU button. | CH – | |
| ||
| MENU | BACK |
| VCR CHANNEL+ | VCR/DVD |
Basic Operation |
| POWER |
Turn the monitor on and off by pressing the POWER button at the top right corner of the remote. The POWER LED will light blue.
• Make sure the MONITOR/CATV switch is set to MONITOR. Move the switch to |
|
CATV only if you need to operate a cable box. | MONITOR CATV |
• | Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to DVD to |
|
| control a DVD player. Please see pages 25 - 28 for instructions on programming |
|
| your remote control to operate a cable box, VCR or DVD player. | VCR DVD |
Note:
• If the lamp replacement message appears when you turn the monitor ON, see page 62.
13
Downloaded from www.Manualslib.com manuals search engine
