MKT-0027-UMN-1.002F

JVC HR-1080-PRO Video Processor User Manual

4.2.1 Operate Mode

Operate Mode is entered by toggling the Operate/Setup button on the IR remote. A brief transition of about 3 seconds occurs when Operate Mode is entered. During this transition period, the 24 x 2 LCD Display indicates

JVC HR-1080-PRO

Please Wait

In Operate Mode, the video output signals are activated and you may control all of JVC HR- 1080-PROparameters with the remote control (except for Setup restricted parameters, as noted below). The LCD front panel display indicates the following information in its 24 x 2 character matrix:

(Selected Input Connector) = (Input Signal Detected) Output = (Output Resolution currently selected)

Depending on which IR remote key that you select, the operation of the OSD is slightly different.

If you select the Menu key, the JVC HR-1080-PROOSD appears on the screen. Complete details on the OSD may be found in chapter 5. The OSD remains on the screen until you press the Menu key once again or until 30 seconds with no IR remote activity passes.

If you select one of the dedicated HQV Feature keys, the HQV feature is immediately activated. A brief message indicating the status of the selected HQV feature appears momentarily on the screen (e. g. TRNR = Medium or CNR = Off).

If you select one of the Input Source keys, the selected source is chosen as the input. The previously selected HQV Features, Aspect Ratio Treatment, Scaling and Video Parameters are all preserved for each input; each input will appear exactly as you left it.

The JVC HR-1080-PROpowers up in Operate mode. All operational parameters are retained from the previous session. A Factory Reset returns all parameters to the default state (defaults are described in chapter 5 except for the input signal. The input signal most recently used is retained as the power-up input signal.

4.2.2 Setup (Stand-by) Mode

Setup mode is entered by toggling the Operate/Setup button on the IR remote.

In Setup mode JVC HR-1080-PROis in a low-power state. The output signals are de-activated (no output will appear on your display device). Setup mode enables you to power the unit down, but still leaves the IR receiver circuitry energized so that you can re-start the system with the IR remote. When the unit is in Setup Mode, you can also make adjustments to certain sensitive

Page 16

JVC Inc.