JVC HR-DD750U manual Access DBS Receiver, SET DBS Receiver Brand

OK

CH

	1	2	3
			2
NUMBER	4	5	6

7 8 9

0 4

1

3 OK

EN21

	ACCESS DBS RECEIVER
7	BRAND SET SCREEN
	Press OK.
8	SET DBS RECEIVER BRAND
	Press the appropriate	DBS RECEIVER BRAND SET
	NUMBER keys to enter the
	DBS Receiver Code from			4 0
	the following list, then
	press OK.
		PRESS NUMBER KEY (0–9)
		THEN (OK) TO TEST
		PRESS (MENU) TO END
	BRAND			CODE
	JVC (DISH Network)		51
	ECHOSTAR (DISH Network)		51
	PRIMESTAR		50
	SONY (DSS)		41
	RCA (DSS)		40
	● After OK is pressed, the program currently received
	through the DBS receiver will appear for about 10
	seconds.
	● If the DBS receiver's channel changes to the channel
	listed below for your brand of DBS receiver, setting is
	complete. Press OK and "DBS RECEIVER CONTROL
	IS ON" appears on the screen for about 5 seconds,
	then it returns to the normal screen.
	JVC [ 100
	ECHOSTAR [ 100
	PRIMESTAR [ 55
	SONY [205
	RCA [205
	● If the DBS receiver's channel does not change as
	shown above, press CH 5° or %Þ to move the
	highlight bar (arrow) to "NO", then press OK. Re-
	enter the correct code.

NOTES:

●It is possible that the Controller will not work with all types of DBS receiver.

●If your DBS receiver doesn’t respond to the code, you can’t use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●The VCR can only change the satellite channel through the Controller during timer recording.

●If your DBS receiver is one that can’t be operated with a remote control (because it has no remote sensor), you can’t use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●For customers in U.S.A.: If you are unable to set the Control- ler, please contact JVC toll free at 1-800-252-5722.