JVC HR-DD750U manual Engage Timer Mode

PRESS (8=DAILY, 9=WEEKLY STOP+/– = STOP TIME, SP/EP)

PRESS (OK) TO END

1	2	3		NUMBER	"9"
4	5	6	2

		E	N	39
CHECK PROGRAM DATA
The PlusCode number you		PROGRAM 1
entered and the matching	(VCR PLUS+ 12345678)
5 Timer-Recording informa-	START		STOP
	8:00PM	= 10:00PM
tion is displayed on the	DATE		CH
Program screen. Check to	12/24/98		12 SP
make sure it’s accurate.	THU

● To change the stop time, press STOP +/–.

● To timer-record daily or weekly serials, press DAILY

(NUMBER “8”) or WEEKLY (NUMBER “9”). “DAILY”

or “WEEKLY” appears on the Program screen.

NUMBER "8"7 8 9

CANCEL0

STOP+/–

PROG. 1

TIMER

4

Pressing the button again makes each corresponding

display disappear.

● If you made a mistake, press CANCEL to access the

VCR Plus+ screen again and input the correct

PlusCode number.

● If the PlusCode number you inputted is incorrect,

"ERROR" may appear on the screen to advise you of

the error. This happens when the PlusCode number is

for a program which has already passed. "ERROR" is

	SP/EP
3	OK

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 2: The program that is broadcast earlier will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 3: The program that is broadcast earlier will be recorded, followed by the remaining portion of the other program.

10:00	11:00	12:00
Program 1	CH10
	Program 2
			CH40

Not recorded

displayed for about 5 seconds and the VCR Plus+

screen reappears.

SET TAPE SPEED

6 Press SP/EP.

RETURN TO NORMAL

SCREEN

7 Press PROG. or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears.

ENGAGE TIMER MODE

8 Press TIMER. The VCR turns off automatically and "ä" is displayed on the display panel.

IMPORTANT

If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR or CABLE CH number will be displayed on the VCR Plus+ Program screen in step 5. When this happens, set the correct the Guide Channel number for that station. (☞ pg. 40, "VCR Plus+ Setup")

NOTES:

●To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.

●In case of a power failure after programming, the VCR’s memory backup keeps your selections for approximately 10 minutes.

●When timer-recording cable channels received through a Cable Box, be sure to keep the Cable Box set to ON.