JVC HR-J351EM Activate Index Search, Activate Instant Review, Index Search Next Function Memory

					E	N	13
Index Search			Next Function Memory
Your recorder automatically marks	£	2	You can set your recorder's power to go off automatically after
index codes at the beginning of			the tape is fully rewound. Before starting, make sure the
each recording. This function gives			recorder is in the Stop mode.
you quick access to any one of 9			For Automatic Power Off After Tape Rewind . . .
index codes in either direction.			. . . press REW, then press	within 2 seconds.

NOTE:

Before starting, make sure the recorder is in the Stop mode.

Tape Position Indicator

ACTIVATE INDEX SEARCH

1 Press PUSH JOG Þor %on the remote control. “ª 1” or “£ 1” is displayed on screen and search begins in the corresponding direction.

●To access index codes 2 through 9, press PUSH JOG

Þor % repeatedly until the correct index number is displayed.

Ex.: To locate the beginning of B from the current

The tape position indicator
appears on screen when, from
the Stop mode, you press FF,
REW or perform an Index
Search. The position of “5” in
relation to “0” (beginning) or		0	+
“+” (end) shows you where you
are on the tape.
”O.S.D.” (☞ pg. 8) must be
set to “ON”, or the indicator
	Beginning
will not appear.

3

+ +

1:23:45

End

position, press PUSH JOG Þtwice.

To locate the beginning of D from the current position, press PUSH JOG %once.

Current position

A	B		C	D E	F
–2		–1	1	2	3
		%		%	Index	number

●When the specified index code is located, playback begins automatically.

Instant ReView

Simply by pressing a single button, the recorder power comes on, rewinds, and begins playback of the last timer-recorded programme. If you have several programmes recorded, you can easily access any of them.

NOTE:

Before starting, make sure that the recorder is off and that the Timer mode is disengaged.

ACTIVATE INSTANT

REVIEW

1 Press REVIEW. The recorder power comes on and the recorder searches for the index code indicating the start of the last timer-recorded programme. Once it’s found, playback begins automatically.

●The front display panel tells you how many programmes have been recorded. If you have, for example, 3 programmes, “REVIEW” and "3" appear and blink. To watch the first of the 3 programmes, press REVIEW three times. The recorder searches and begins playback automatically. You can access a programme as far as 9 index codes away from the current tape position.

NOTE:

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.

Instant ReView is not possible while the recorder is in the Timer mode.