JVC HR-J777MS, HR-J677MS specifications Return to Normal, Engage Recorders, Timer Mode

	1	2	DAILY 2
			3
NUMBER	4	5	6
	7	8	9	WEEKLY
		0	4

STOP+/–

1

PROG

3 OK

PUSH JOG

EN25

	RETURN TO NORMAL
5	SCREEN
	Press PROG or OK. "PROGRAM COMPLETED" appears
	on the screen for about 5 seconds, then normal screen
	appears.
	● Repeat steps 1 – 5 for each additional programme.
	ENGAGE RECORDER'S
6	TIMER MODE
	Press ä. The recorder turns off automatically and "ä"
	appears on the display panel.
	● To disengage the timer, press ä again.

NOTES:

●To Change The Stop Time . . .

. . . press STOP +/– after pressing OK in step 3. You can compensate for anticipated programme schedule delays this way.

●To Timer-Record Weekly Or Daily Serials . . .

. . . after pressing OK in step 3, press WEEKLY (NUMBER key "9") for weekly serials or DAILY (NUMBER key "8") for daily serials (Monday – Friday). Either "WEEKLY" or "DAILY" appears on the screen. Pressing the button again makes the corre- sponding indication disappear.

●You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 28).

●It is not possible to timer-record a TV programme with a G-CODEnumber which starts with "0".

Satellite Tuner Users

To timer-record a satellite broadcast using the G-CODESystem:

1Perform steps 1 – 6.

2Set the satellite tuner to the appropriate channel before the selected programme begins.

3Leave the satellite tuner's power on.

ATTENTION

Regarding Guide Program Number Set

"G-CODE/SHOWVIEW SETUP" appears after performing step 3 if the Guide Program number for the G-CODEnumber you entered has not been set.

●Press the NUMBER keys or PUSH JOG %Þ to input the channel position number on which your recorder

receives that station, then press OK or PUSH JOG %. The G-CODEprogram screen appears.

G-CODE/SHOWVIEW SETUP

GUIDE PROG	TV PROG
2	– –

[0-9] OR [5/°]:SELECT = [PROG] : EXIT

(Ex.) To timer-record a RTR programme with the G-CODESystem.

*If your recorder receives RTR on the channel position 2, press OK or PUSH JOG % after entering "2".