JVC HR-J677MS, HR-J777MS Remote Control Functions, Remove Power Supply, SET Remote Control Code

32ENSPECIALFEATURES

Remote

Control

Functions

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

REMOVE POWER SUPPLY

1 Unplug the mains power cord from the mains outlet.

VCR

NUMBER "1"	1		2	3
	4		5	6
	7	"2"	8	9
	NUMBER		0
	1

3

2

4

OK

SET REMOTE CONTROL

CODE

2 While holding down VCR on the remote control, press the NUMBER key "2" and then press OK.

RE-SUPPLY POWER

3 Plug the mains power cord back into the mains outlet.

TURN THE RECORDER ON

4 Press on the remote control. The recorder will now only respond to B code signals.

NOTE:

To set the recorder back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2.