JVC HR-P51A manual Recording, Editing To/From Another Recorder, Player

Recording

Use the following procedure to record TV programmes on a blank video tape.

Before proceeding:

∙To record TV programmes, the video cassette player must be connected to the TV as shown in connection B of the “Connections” section.

∙Turn on the power of the TV and video cassette player.

∙Make sure that the video cassette’s safety tab is intact. If it has been removed, cover the hole with adhesive tape.

1	2			TV
		-	TVCH		+	OPERATE
		-	VOLUME		+	TV/VIDEO
				VIDEO
		TV/VIDEO				OPERATE
	INTELLIGENT	AUTO		- TRACKING +			2
	PICTURE
OPERATE STANDBY
SP/LP/EP	NTSC

Editing

Editing To/From Another Recorder

Player

40	10-
32
RF OUT	IN	OUT
K	AUDIO
G
ANT.
IN	VIDEO
1-

Audio/Video signals

NTSC 3.58/4.43		ON PAL TV	(+	-	+ (
	INTELLIGENT	NTSC3.58
RECORDING & PLAYBACK	PICTURE LP/EP	NTSC4.43
			[	L	J
			REMOTE CONTROL UNIT

1 Load a blank video tape.

2 Press the Record ¦ button to start recording. (On the remote control unit press the Record ¦ and Play 3 button at the same time.)

40

32

RF OUT

K

G

ANT.

IN

1-

Recorder

TV

Receiver

10-

IN OUT

AUDIO

VIDEO

VIDEO CHANNEL

The recording indicator will light during recording.

7Press the Stop/Eject ¤button or the remote control’s Stop & button to stop recording.

To stop recording temporarily:

7Press the Pause 8 button.

The recording indicator will blink.

Press the Play 3 button to resume recording.

Notes:

∙To engage recording standby, press the Record ¦ button and then press the Pause 8 button. The recording indicator will blink during recording standby. Press the Play 3button again to start recording.

∙If the Record button does not work, check to see if the cassette safety tab has been removed.

∙The player automatically stops when record-standby contin- ues for more than 5 minutes.

∙The video tape will be rewound automatically when the end of the tape is reached.

1 Connect the player’s AUDIO and VIDEO OUT connectors to the recorder’s AUDIO and VIDEO IN connectors.

2 Put the player in the Play mode.

3 Put the recorder in the Record mode.

Notes:

∙NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder.

∙When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch.

Important:

7To edit, both the player and the recorder must be of the same colour system. Press your recorder’s Colour sys- tem switch to select the appropriate colour system.

9