subsidiary information56
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
TIMER RECORDING (cont.)
7. U, , and the SAT c indicator
won’t stop blinking.
8. Uand , on the display panel
won’t stop blinking.
• The loaded cassette has had its
record safety tab removed.
• The end of the tape was
reached during Auto Satellite
Programme Recording.
• The end of the tape was
reached during Instant Timer
Recording.
Remove the cassette and cover
the hole with adhesive tape, or
insert a cassette with the record
safety tab intact.
The programme may not have
been recorded in its entirety. Next
time make sure you have enough
time on the tape to record the
entire programme.
The programme may not have
been recorded in its entirety. Next
time make sure you have enough
time on the tape to record the
entire programme.
OTHER PROBLEMS
1. Whistling or howling is heard
from the TV during camcorder
recording.
2. When scanning channels, some
of them are skipped over.
3. The preset cannot be changed.
4. Channel settings that were
made manually seem to have
changed or disappeared.
5. No channels are stored in the
VCR’s memory.
• The camcorder’s microphone is
too close to the TV.
• The TV’s volume is too high.
• Those channels have been
designated to be skipped.
• Recording is in progress.
• After the manual settings were
made, Auto Channel Set was
performed.
• The TV aerial cable was not
connected to the VCR when
Auto Set Up was performed.
Position the camcorder so its
microphone is away from the TV.
Turn the TV’s volume down.
If you need the skipped channels,
restore them.
Press | to pause the recording,
change presets, then press . to
resume recording.
Perform manual setting again.
Turn off the VCR once and connect
the TV aerial cable to the VCR
properly, then turn on the VCR
again. Then perform Auto Setup
again (墌pg.10).
HR-S5965/5966EK-EN/p52-59 4/7/03, 04:02 PM56