three step quick start 11
FINISH AUTO SETUPPress OK button and move on to Step 2 to check the results.
oops! If there is a power cut or you accidentally press a button during Auto Setup, turn the VCR off and then on again.
Preset Download
before you start
Check that the VCR is turned off and no cassette is inserted
Load the battery into the Remote Control
Refer to the Remote Control diagram on pages
Press the obutton. The display panel on the front of the VCR will show the word ‘Auto’. Press the PR 
and PR 
buttons to select ‘CH – 
).
what will happen? The VCR is automatically setting up the tuner channels by downloading from your TV, clock and the VIDEO Plus+ system assigned Guide Program numbers. During downloading, preset position on the display panel increases from “CH1”.
SAT
VCR
REVIEW
SAT
VCR
REVIEW
Preset Download is running:
don’t touch any buttons
Unless indicated otherwise, use the buttons on the Remote Control
rf and scart connection If the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:
Check that the connection is completed
Be sure to use the fully- wired
Turn on the TV whose channels have already been stored
–
PLEASE WAIT
Your TV screen during Preset
[MENU]: EXIT | Download |
|
| SET THE VIDEO CHANNEL TO OFF |
| |
When Preset Download has finished, ‘COM- |
|
|
| SAT | |
PLETED’ appears on the TV screen. Press oto |
| |
| VCR | |
turn off the VCR. Press and hold down Son |
| REVIEW |
|
| |
|
|
|
the VCR until you will see the display on the |
| |
right. Press PR |
| |
Press OK button and move on to Step 2 to check the results.
oops! If there is a power cut or you accidentally press a button during Preset Download, turn the VCR off and then on again.
•In areas where no TV station transmits the PDC signal, the VCR cannot setup either the clock or Guide Program numbers.
•On this VCR, the characters available for station names (ID) are
*, + and
(space). The names of some downloaded stations may differ from those on your TV.