JVC HR-VP672U, HR-VP472U manual SET Channel Number, Engage Timer Mode

UMBER	2	3
1
"8"	5	6
4
7	8	9
	0

PROG. 1

2

NUMBER "9"

TIMER

4

CH+/–

EN35

7	SET CHANNEL NUMBER
	Press CH +/–.
	Holding down CH +/– rapidly scans through the
	channels.
	If you are using a cable box, enter the cable box
	channel, not the channel to be recorded. The channel
	to be recorded must be selected on the cable box.
	(The cable box channel is the VCR’s channel that
	displays the channels received by the cable box.)
	To timer-record cable or DBS channels through an
	external tuner connected to the VCR’s external input
	connectors, press the NUMBER key "0" so that "F-1"
	appears instead of a channel number.
	SET TAPE SPEED
8 Press SP/EP to set the tape speed.
	RETURN TO NORMAL

	SP/EP
3	OK

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 2: The program that is broadcast earlier will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 3: The program that is broadcast earlier will be recorded, followed by the remaining portion of the other program.

10:00	11:00	12:00
Program 1	CH10
	Program 2
			CH40

Not recorded

	SCREEN
	Press PROG. or OK. "PROGRAM COMPLETED"
	appears on the screen for about 5 seconds, then normal
9 screen appears.
10	ENGAGE TIMER MODE
	Press TIMER. The VCR turns off automatically and "ä"
	is displayed on the display panel.

To Timer-Record Weekly Or Daily Serials . . .

. . . anytime during steps 3 through 9, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials (Monday–Friday). Either "WEEKLY" or "DAILY" appears on the screen. Pressing the button again makes the corresponding indication disappear.

NOTES:

To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.

In case of a power failure after programming, the VCR’s memory backup keeps your selections for approximately 10 minutes. Programs that start after midnight must have the next day’s date. After timer recording is completed, the VCR’s power goes off automatically.

You can program the timer while a regular recording is in progress; the on-screen menu will not be recorded.

If the end of tape is reached during timer recording, the cassette is automatically ejected.

When timer-recording cable or satellite channels through an external tuner, be sure to keep the cable box or satellite receiver's power ON.