JVC HR-VP653U, HR-VP453U PlusCode number you, Entered and the matching, Timer-Recording informa

SET TAPE SPEED

Press SP/EP.

RETURN TO NORMAL SCREEN

Press PROG. or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears.

ENGAGE TIMER MODE

Press TIMER. The VCR turns off automatically and "ä" is displayed on the display panel.

PRESS (8=DAILY, 9=WEEKLY

EN 31

CHECK PROGRAM DATA

NUMBER		1	2	3		NUMBER	"9"
		4	5	6	2
	"8"
		7	8	9
CANCEL			0		4	TIMER
					STOP+/–
PROG.	1
				SP/EP
				3		OK

ATTENTION

If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.

Pattern 1: The program with the lower program number will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 2: The program that is broadcast earlier will be recorded.

10:00	11:00	12:00
Program 1	CH10
Program 2			Not recorded
	CH40

Pattern 3: The program that is broadcast earlier will be recorded, followed by the remaining portion of the other program.

10:00	11:00	12:00
Program 1	CH10
	Program 2
			CH40

Not recorded

The PlusCode number you		PROGRAM 1
entered and the matching		(VCR PLUS+ 12345678)
5 Timer-Recording informa-		START	STOP
	8:00PM		= 10:00PM
tion is displayed on the	DATE		CH
Program screen. Check to	12/24/98		12 SP
make sure it’s accurate.	THU

● To change the stop time,	STOP+/– = STOP TIME, SP/EP)
	PRESS (OK) TO END
press STOP +/–.

● To timer-record daily or weekly serials, press DAILY (NUMBER “8”) or WEEKLY (NUMBER “9”). “DAILY” or “WEEKLY” appears on the Program screen.

Pressing the button again makes each corresponding display disappear.

● If you made a mistake, press CANCEL to access the VCR Plus+ screen again and input the correct PlusCode number.

● If the PlusCode number you inputted is incorrect, "ERROR" may appear on the screen to advise you of the error. This happens when the PlusCode number is for a program which has already passed. "ERROR" is displayed for about 5 seconds and the VCR Plus+ screen reappears.

6

7

8

IMPORTANT

If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR or CABLE CH number will be displayed on the VCR Plus+ Program screen in step 5. When this happens, set the correct the Guide Channel number for that station.

(☞ pg. 32, "VCR Plus+ Setup")

NOTES:

●To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.

●In case of a power failure after programming, the VCR’s memory backup keeps your selections for approximately 10 minutes.

●When timer-recording cable channels received through a Cable Box, be sure to keep the Cable Box set to ON.