JVC HX-Z1 Put a cassette in with the exposed part of the, tape down, Playing Back Tapes, English

Playing Back Tapes

You can play back type I tapes without changing any settings. To play both sides repeatedly—Reverse Mode

When using Reverse Mode, the tape automatically reverses at

Playing Back a Tapethe end of a side and the unit starts playing for the other side of the tape, and repeats the same process.

1 Press 0EJECT for the cassette deck.	On the unit ONLY:
	To use Reverse Mode, press REVERSE MODE		REVERSE
			MODE
	so that the Reverse Mode indicator on the display
	lights up like—	.
	To cancel Reverse Mode, press the button again so that the
	Reverse Mode indicator on the display lights up like—		.

2 Put a cassette in with the exposed part of the	Locating the Beginning of a Song—Music Scan
tape down.	You can use Music Scan to locate the beginning of a song.
	Music Scan searches for blank portions that usually separate
	recorded songs, then plays the next song.

English

3	Close the cassette holder gently.
4	Press TAPE 23.	TAPE

The tape play starts and the tape direction indicator (3or 2) starts flashing slowly to indicate the tape running direction.

•Each time you press the button, the tape direction changes and “REVERSE” appears for a while on the display.

3: plays the front side.

2: plays the reverse side.

•If no cassette is inserted, “NO TAPE” appears on the display.

When the tape plays to the end, the deck automatically stops if the Reverse Mode is off. (See “To play both sides repeatedly—Reverse Mode.”)

To stop playing, press 7.

To fast-wind to the left or to the right, press 1 or Á(or

4(1) / ¢ (Á) on the remote control) while the tape is not running.

The tape direction indicator (3 or 2) starts flashing quickly on the display.

To remove the cassette, press 0EJECT to open the cassette holder.

The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

To find the beginning of the current song

During play, press 1 or Á (or 4 (1) / ¢(Á) on the

remote control) in the opposite direction to the tape play.

The tape direction indicator of the

opposite direction to the tape play starts flashing intermittently.

Searching stops automatically at the beginning of the current song, and the current song starts automatically.

To find the beginning of the next song

During play, press 1 or Á (or 4 (1) / ¢(Á) on the

remote control) in the same direction as the tape play.

The tape direction indicator of the

same direction as the tape play starts flashing intermittently.

Searching stops automatically at the beginning of the next song, and the next song starts automatically.

Music Scan works by detecting a 4-second long blank between each song, so it will not work well in the following cases

•No blank at the beginning of a song.

•Noise (often caused by much use or poor quality dubbing) which fills the blank.

•Long, very soft passages or pauses in a song.

– 18 –