Connecting to Remote Control Unit RM-P210 (continued)
GENLOCK IN VIDEO OUT
DC IN | POWER | Rear view of |
SEE INST |
|
|
|
| this unit |
INCOM MIC | VF | |
ON | CARBON |
|
OFF | DYNAMIC |
|
INTERCOM |
|
|
INCOM LEVEL | CALL | |
PUSH |
|
|
MIN MAX |
|
[CARBON/DYNAMIC] switch
[INCOM MIC ON/OFF] switch
Switch setting
●Set the [CARBON/DYNAMIC] switch according to the type of intercom headset microphone to be used. (If JVC Headset
●Set the [INCOM MIC ON / OFF] switch depending on whether headset microphone will be used. If the switch is set to [ON], then the headset microphone could be used.
English
Operation
●Turn the [POWER] switch of the camera remote control unit to [ON]. After the [POWER] switch is turned on, camera remote control unit could be operated after about 30 seconds.
Note
After the power is turned on, the camera remote control unit takes about 30 seconds to be ready to communicate with this unit.
GENLOCK IN | VIDEO OUT |
DC IN | POWER |
SEE INST |
|
INCOM MIC | VF | |
ON | CARBON |
|
INTERCOM | OFF DYNAMIC | [CALL] | |
|
| ||
| INCOM LEVEL CALL |
| |
PUSH |
| Indicator | |
| MIN MAX | ||
[INCOM LEVEL] | [CALL] button | ||
volume | |||
|
|
●When this unit’s [CALL] button is pressed and held down, call signals will be sent to the remote control unit operator and the [TALLY] button indicator of the remote control unit will blink.
During this duration, the [CALL] indicator of this unit will light up. The Viewfinder’s [TALLY] lamp will also blink when call signals are received from the re- mote control unit.
●The headset reception volume could be adjusted by [INCOM LEVEL] volume.
Note
●If both this unit (including the camera) and the remote control unit have the same func- tional switches, the remote control unit switches will be accorded higher priority.
●If local Remote Control Unit
●When synchronization signal is added to both the camera and the camera remote con- trol unit, pictures will be distorted. (☞ page 9 ‘Regarding
●If external synchronization signal is present when the power is turned on, pictures may appear jerky for a few seconds. This is not a malfunction.
●When using the remote control unit, refer to its instruction manual for details.
19