![](/images/new-backgrounds/1043265/4326585x1.webp)
KD-G116/KD-G115
Installation/Connection Manual
Manual Pemasangan/Penyambungan
[UN]
ENGLISH
1004DTSMDTJEIN EN, IN
INDONESIA
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
Alat penerima ini didisain untuk beroperasi hanya pada 12 V DC, sistem listrik tanah NEGATIVE. Jika kendaraan anda tidak memiliki sistem ini, sebuah pembalik tegangan diperlukan, yang mana dapat dibeli di
Parts list for installation and connection | Daftar |
The following parts are provided for this receiver. After checking them, please set them correctly.
Setelah mengecek
A / B |
| C | D | E |
Hard case/Control panel |
| Sleeve | Trim plate | Power cord |
Kotak keras/Panel (Papan) |
| Selongsong | Plat rapi | Kabel power |
kontrol |
|
|
|
|
F | G | H | I | J |
Washer (ø5) | Lock nut (M5) | Mounting bolt (M5 x 20 mm) | Rubber cushion | Handles |
Perapat | Mur kunci (M5) | Baut bingkai (M5 x 20 mm) | Bantalan karet | Pegangan |
sambungan (ø5) |
|
|
| |
INSTALLATION | PEMASANGAN |
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
•If you are not sure how to install this receiver correctly, have it installed by a qualifi ed technician.
*1 When you stand the receiver, be careful not to damage the fuse on the rear.
*1 Ketika anda memberdirikan alat penerima,
Ilustrasi berikut menunjukkan sebuah tipe pemasangan. Jika anda mempunyai suatu pertanyaan atau informasi yang diperlukan mengenai
•Jika anda tidak yakin bagaimana memasang alat penerima ini dengan benar, biarkan dipasang dengan teknisi yang berkualitas.
Do the required electrical connections. Lakukan
Bend the appropriate tabs to hold the sleeve fi rmly in place.
Bengkokkan
Removing the receiver | Memindahkan alat penerima |
Before removing the receiver, release the rear section.
Sebelum memindahkan alat penerima, lepaskan seksi belakang.
Insert the two handles, then pull them as illustrated so that the receiver can be removed.
Sisipkan kedua pemegang dan tarik alat penerima seperti yang diilustrasikan hingga alat penerima dapat dipindahkan.
When using the optional stay / Ketika menggunakan penguat tambahan
Fire wall
Dinding tahan api
Dashboard |
| |
Tempat alat pada bagian | Screw (option) | |
depan (dashboard) | ||
Sekrup (tambahan) | ||
|
Install the receiver at an angle of less than 30˚.
Pasang penerima pada suatu sudut lebih dari 30˚.
When installing the receiver without using the sleeve / Ketika memasang alat penerima tanpa menggunakan selongsong
In a Toyota for example, fi rst remove the car radio and install the receiver in its place.
Dalam sebuah Toyota misalnya, pertama pindahkan radio mobil dan pasang alat penerima tersebut ke dalam tempatnya.
Flat type screws |
| * Not included for this receiver. | |
| * Tidak termasuk dengan alat | ||
(M5 x 8 mm)* |
| ||
| penerima ini. | ||
Bracket* | |||
| |||
(M5 x 8 mm)* | Breket* | Flat type screws | |
| |||
|
| (M5 x 8 mm)* | |
Bracket* | |||
Kantong | (M5 x 8 mm)* | ||
| Breket* |
|
Note : When installing the receiver on the mounting bracket, make sure to use the 8
Catatan: Ketika memasang alat penerima pada breket bingkai, pastikan untuk menggunakan
TROUBLESHOOTING
•The fuse blows.
* Are the red and black leads connected correctly?
•Power cannot be turned on. * Is the yellow lead connected?
•No sound from the speakers.
* Is the speaker output lead
•Sound is distorted.
*Is the speaker output lead grounded?
*Are the
•Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
•Receiver becomes hot.
*Is the speaker output lead grounded?
*Are the
•This receiver does not work at all. * Have you reset your receiver?
PEMECAHAN MASALAH
•Sekring meledak.
*Apakah
• Power tidak dapat dihidupkan.
*Apakah ujung kuning sudah tersambung?
•Tidak ada suara dari speker.
*Apakah ujung keluaran speker terhubung pendek?
• Suara terdistorsi.
*Apakah ujung keluaran speker sudah ditanahkan?
*Apakah
• Berisik yang mengganggu suara-suara.
*Apakah terminal tanahan belakang tersambung ke casis mobil menggunakan
•Alat penerima menjadi panas.
*Apakah ujung keluaran speker sudah ditanahkan?
*Apakah
•Alat penerima ini tidak bekerja secara keseluruhan.
* Apakah anda sudah reset (memasang kembali) alat penerima anda?
1