3 Tune in to a station you want while “M” (manual) is still flashing.To tune in to stations of higher frequenciesTo tune in to stations of lower frequencies

•If you release your finger from the button, the manual mode will automatically turns off after 5 seconds.

•If you hold down the button, the frequency keeps changing—in 50 kHz intervals (87.5 MHz – 108.0 MHz for FM 1 and FM 2), in 30 kHz intervals (65.00 MHz – 74.00 MHz for FM 3) and 9 kHz for AM —MW/LW until you release the button.

When an FM stereo broadcast is hard to receive:

1Press MODE to enter the functions mode while listening to an FM stereo broadcast.

2Press MO (monaural), while“MODE” is still flashing on the display, so that “MONO” appears on the display.Each time you press the button, monaural mode turns on and off alternately.MO (monaural) indicator

When the MO indicator is lit on the display, the sound you hear becomes monaural but the reception will be improved.

Storing stations in memory

You can use one of the following two methods to store broadcasting stations in memory.

•Automatic preset of FM stations: SSM (Strong- station Sequential Memory)•Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM band (FM1, FM2, and FM3).1 Select the FM band (FM1 – 3) you want to store FM stations into.Each time you press the button, the band changes as follows:

FM1 FM2 FM3 AM

2 Press MODE to enter the functions mode.3 Press and hold SSM for about2 seconds.“SSM” flashes, then disappears when automatic preset is over.

Local FM stations with the strongest signals are searched and stored automatically in the band number you have selected (FM1, FM2, or FM3). These stations are preset in the number buttons —No.1 (lowest frequency) to No.6 (highest frequency).

When automatic preset is over, the station stored in number button 1 will be automatically tuned in.

ENGLISH

9