Installation/Connection Manual
Manual de instalación/conexión
[J]
ENGLISHESPAÑOL
PREPARATIONS
You need the installation kits which corresponds to your car.• Mark all the check boxes ( 
) to make sure you have follow the instructions and the listed parts.
TROUBLESHOOTING
•The fuse blows.* Are the red and black leads connected correctly?•Power cannot be turned on. * Is the yellow lead connected?
•No sound from the speakers.* Is the speaker output lead* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
•This unit becomes hot.*Is the speaker output lead grounded?
*Are the
•This unit does not work at all. * Have you reset your unit?
Parts list for installation and connection
A/B | C | D | E |
| Hard case/ | Sleeve | Trim plate | Power cord |
| Control panel |
|
|
|
F | G | H | I |
| Direct connection | Washer (ø5) | Lock nut (M5) | Mounting bolt— |
| cable for iPod |
|
| M4 × 5 mm (M4 × 1/4"); |
|
|
| M5 × 12.5 mm (M5 × 1/2") |
J | K | L | M |
| Rubber cushion | Handles | Remote controller | Battery |
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
In |
| Removing the unit |
| Before removing the unit, release the rear section. | |
Do the required electrical connections.
When you stand the unit, be careful not to damage the fuse on the rear.
Bend the appropriate tabs to hold the sleeve firmly in place.
When using the optional stay
| Fire wall | Stay (option) |
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
| Flat type screws | * Not supplied for this unit. | |
| ||
| Bracket* |
| |
| Flat type screws | |
| ||
Bracket* |
|
1