JVC KD-S35 ELECTRICAL CONNECTIONS, Typical connections, Connecting the external amplifiers and/or subwoofer, Connecting an Apple iPod, Note:, Set “L/O MODE” to “REAR”

ELECTRICAL CONNECTIONS

Make sure to disconnect the battery’s negative terminal.

• Be sure to ground this unit to the car’s chassis again after installation.

Note:

It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS).

HighHeat sink

Typical connections

Antenna terminal

Rear line out

Rear ground terminal

15 A fuse iPod connector

Ignition switch

Connect only the front speakers if your		Black	To metallic body or
			To metallic body or
			chassis of the car
speaker system is two-speaker system.			chassis of the car
speaker system is two-speaker system.
White with black stripe			To a live terminal in the
White with black stripe		*Yellow 2**	fuse block connecting to the
		*Yellow 2**	fuse block connecting to the
			car battery (bypassing the
Front speaker (left)	White		ignition switch) (constant
Front speaker (left)	White		12 V)
			12 V)
			Fuse block
Gray with black stripe		Red	To an accessory terminal in
		Red	To an accessory terminal in
Front speaker (right)	Gray		the fuse block
Front speaker (right)	Gray
Green with black stripe		Blue with white	To the remote lead of other
		stripe	To the remote lead of other
		stripe	equipment or automatic antenna if
			equipment or automatic antenna if
Rear speaker (left)	Green		any (200 mA max.)
Rear speaker (left)	Green
Purple with black stripe
Rear speaker (right)	Purple

PRECAUTIONS on power supply and speaker connections

Connecting the external amplifiers and/or subwoofer

	Remote lead	*Y-connector 1**
Set “L/O MODE” to “REAR”	Remote lead (blue with white stripe)
(See page 15 of the		To the remote lead of other equipment
INSTRUCTIONS.)		To the remote lead of other equipment
		or automatic antenna if any

JVC Amplifier

Rear speakersFront speakers

Set “L/O MODE” to “SUB. W” (See page 15 of the INSTRUCTIONS.)

Remote lead

JVC Amplifier

Subwoofer*1 Not supplied for this unit.

*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.

*3 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place not coated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*4 Signal cord (not supplied for this unit).

Connecting an Apple iPod

You can connect an iPod to this unit using the supplied direct connection cable for iPod.

iPod is a trademark of Apple Inc., registered in the U.S. and other countries.Apple iPod (separately purchased)Direct connection cable for iPod (supplied)