Other RDS functions
EON (Enhanced Other Networks)
•When tuning in a broadcasting station transmitting EON data, the EON indicator is lit and the following operations start.
EON automatically stores the frequencies of stations from other networks transmitting information codes (TP/TA/AF/PTY/PS (Programme Service), etc.) so they can be mutually used. The following points have been improved:
When listening to a station NOT transmitting traffic information or the selected PTY for example, EON automatically tunes to a station in a local network when this information is broadcast and then switches back to the original programme when the broadcast ends. (However, it does not switch back to the original programme if the broadcast continues for a long time.) The transmitted information (AF and other codes) is constantly and automatically updated so that preset programme information can be heard immediately even if in a different network area.
Traffic information volume control
This function adjusts the volume of traffic information broadcasts.
1.Press the SEL button for more than 2 seconds to set the preferred setting mode.
2.Select “TA VOL” with the ¢
or 4
button.
3.Set to the desired volume with the + or - button. (See page 25.)
Number buttons
When a number button is pressed, if the station with that frequency is broadcasting a sufficiently strong signal, the receiver will tune to that frequency.
When the signal strength is not sufficient for good reception, by referring to the AF list, the receiver searches for a station broadcasting the same programme with a stronger signal. If a station cannot be found in the AF list, PI- seek tuning starts. If a station broadcasting the same PI code cannot be detected in one
CT (Clock Time)
When CT data is received in the RDS signal, the time is correctly renewed.
•RDS updates the local time according to Greenwich Mean Time.
•When automatic renewal of clock time is NOT required, follow the steps below.
1.Press the SEL button for more than 2 seconds to set the preferred setting mode.
2.Select “AUTO ADJ” with the ¢
or 4
button.
3.Press the
Once these steps are completed, clock time is not renewed even if the CT (Clock Time) data is received with the RDS signal. When you wish to reactivate this mode, repeat the same procedure and in Step 3 press the “+” Level Control button to set to “ADJ ON.” In the activated mode, clock time is automatically renewed when the CT data is received.
Note:
It takes at least 2 minutes to renew the time after receiving CT data. The station must be received for more than 2 minutes continuously, otherwise the clock time will NOT be renewed.
ENGLISH
15
