JVC KD-S890 manual Adjusting the sound, Adjust the setting, Select the item you want to adjust

Adjusting the sound 2 Adjust the setting.

You can adjust the sound characteristics to your preference.

1 Select the item you want to adjust.

Each time you press the

button, the adjustable items change as follows:

To increase the level or turn on the loudness

To decrease the level or turn off the loudness

Equalization pattern changes as you adjust the bass or treble.

ENGLISH

			BAS		TRE				FAD
			(bass)		(treble)				(fader)
		VOL			LOUD				BAL
	(volume)				(loudness)			(balance)
Indication				To do:					Range
BAS*1			Adjust the bass.				–06 (min.)
							+06 (max.)
TRE*1			Adjust the treble.				–06 (min.)
							+06 (max.)
FAD*2			Adjust the front				R06 (Rear only)
			and rear speaker
			balance.				F06 (Front only)
BAL			Adjust the left				L06 (Left only)
			and right speaker
			balance.				R06 (Right only)
LOUD*1			Boost low and high
			frequencies to				LOUD ON
			produce a well-
			balanced sound				LOUD OFF
			at low volume level.
VOL*3			Adjust the volume.			00		(min.)
						50		(max.)

*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including “USER.”

*2 If you are using a two-speaker system, set the fader level to “00.”

*3 Normally the control dial works as the volume control. So you do not have to select “VOL” to adjust the volume level.

Ex. 1: When you adjust “TRE” (treble)

Ex. 2: When you turn on the loudness

3 Repeat steps 1 and 2 to adjust the other items.

To reset each sound mode to the factory

settings, repeat the same procedure and reassign the preset values listed in the table on page 22.

23