ENGLISH
Changing the display mode while listening to an FM station
You can change the initial indication on the display to either station name (PS NAME) or to station frequency (FREQ), while listening to an FM RDS station.
• See also “Changing the general settings (PSM)” on page 26.
1.Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
2.Select “TU DISP (tuner display)” with 
¢or 
4.
3.Set to the desired indication (“PS NAME” or “FREQ”) with the control dial.
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the upper part of the display:
PS (Station name) 
Station Frequency 
PTY (Programme type)
* Then, the display goes back to the original indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic programme is received, the volume level automatically changes to the preset level.
• See also “Changing the general settings (PSM)” on page 26.
1.Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
2.Select “TA VOL (volume)” with 
¢or 
4.
3.Set to the desired volume with the control dial.
Automatic clock adjustment
When shipped from the factory, the clock built in this unit is set to be readjusted automatically using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also “Changing the general settings (PSM)” on page 26.
1.Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
2.Select “AUTO ADJ (adjust)” with 
¢or 
4.
3.Select “OFF” by turning the control dial counterclockwise. Now automatic clock adjustment is canceled.
To reactivate clock adjustment, repeat the same procedure and select “ON” in step 3 by turning the control dial clockwise.
Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more than 2 minutes continuously; otherwise, the clock time will not be adjusted.
16
