Tuner Setup

Auto Tuner Setup

The auto tuner setup function is described on page 23 as the interactive plug-in menu. If you need to run the auto tuner setup again, follow the steps below.

 

Press the MENU button

– + Tuner Setup > Auto Tuner Setup

 

 

 

π†

To "Tuner Setup"

 

 

 

 

 

 

 

 

 

 

Tuner Mode

 

 

Air

 

 

è

To enter

 

 

Scan Mode

 

 

Auto

 

 

π†

To "Auto Tuner Setup"

 

 

 

 

 

 

 

 

è

To enter

 

 

 

 

 

 

 

 

è

To choose "Cable" or "Air"

 

 

 

 

 

Start

 

 

 

 

 

 

 

 

 

 

π†

To "Scan Mode"

 

 

 

 

 

 

 

 

è

To choose "Auto", "STD", "HRC" or "IRC"

 

 

 

 

BACK

 

MENU

 

Select

Operate

Back

Exit

 

 

 

 

 

 

 

 

 

†To "Start"

Press the OK button (Programming will take serveral minutes)

The auto tuner is finished when the message "Programming Over !" appears onscreen.

Notes:

•When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"

•If no channels were found using Auto Tuner Setup, check your antenna cable and the settings for Tuner Mode/Scan Mode.

•You can also access the "Front Menu" screen by using the MENU button on the side of the TV instead of the remote control. It has "Video Status", "Aspect", "Auto Tuner Setup" and

"Menu". Choose "Auto Tuner Setup" by pressing MENU† on the side panel and enter by using the CHANNEL +/- buttons ( √ OPERATE ® ).

40