JVC 2B00401C, LPT0719-001A Playback Connection, Connect to a Stereo Amplifier with Audio Output

Playback Connection

Connect to a Stereo Amplifier with Audio Output

If your TV has a COMPONENT VIDEO IN jack, you can connect the DVD/VCR to the TV with a COMPONENT cable (not supplied) as shown below. COMPONENT VIDEO output jack can send higher-quality video signal to a TV than S-Video output.

COMPONENT VIDEO Cord (not supplied)

To Component
Video Output				AUDIO/VIDEO Cord (supplied)		To Audio/Video Input
DVD/VCR				To Audio/Video Output
				Stereo Amplifier
DVD OUTPUT
DIGITAL AUDIO AUDIO	S-VIDEO COMPONENT			IN
OPTICAL COAXIAL	Y	VIDEO
L				(ANT.)
R
	P /C	L
		AUDIO		OUT
	P /C	R		( TV)
			CH.
			3	4
	Audio (L) Output				To Audio (L) Input
	Audio (R) Output

To Audio (R) Input

AUDIO Cord (not supplied)

To

Component

Video Input

TV

Connect to an AV Amplifier with built-in digital surround

If you are using an Amplifier with a built-in digital surround as follows, you can enjoy the various audio systems such as Dolby Digital and DTS by using the Optical or Coaxial Digital Output.

Use this connection to connect an:

•AV amplifier with built-in *Dolby Digital decoder

•AV amplifier with built-in *DTS decoder

	Video cord (not supplied)	To Video
DVD/VCR
	Video Output	Input

		DVD OUTPUT
DIGITAL AUDIO		AUDIO	S-VIDEO	COMPONENT		IN
OPTICAL	COAXIAL	L		Y	VIDEO
						(ANT.)
		R

P /C	L
	AUDIO	OUT
P /C	R	( TV)
		CH.

3 4

Coaxial digital

Audio Output Coaxial digital cable (not supplied)

AV Amplifier with built-in various decoder as above

TV

NOTE:

You may connect to a TV with a Component video cable(not supplied) or S-Video cable(not supplied) instead of a video cable(not supplied).

Connecting the optical digital cable

You may connect to an AV Amplifier with an Optical digital cable (not supplied) instead of a Coaxial digital cable.

When you connect the optical digital cable (not supplied), remove the dust protection cap from the rear panel. When not using the optical digital cable, attach the dust protection cap to protect against dust.

NOTES:

•The OPTICAL, COAXIAL, AUDIO L/R, S-VIDEO and COMPONENT jacks are useful only for DVD section. The VHS signal is output only from the composite jack(DVD/VCR VIDEO OUTPUT) and UHF/VHF OUT.

•When you make the connections above, do not set DOLBY DIGITAL to DOLBY DIGITAL or DTS to ON on the AV Amplifier. If you do, a loud noise will suddenly come out from the speakers, affecting your ears or causing the speakers to be damaged.

•Caution for the optical digital audio output connector: Do not connect to an amplifier (with an optical digital input connector) which does not contain a Dolby Digital or DTS decoder. Otherwise, any attempt to play DVDs may cause such a high level of noise that it may be harmful to your ears and damage your speakers.

•DTS audio will be output only from the COAXIAL or OPTICAL output. To hear DTS audio, DTS-Decoder is necessary.

•When playing DTS-encoded CDs, only noise will be heard from the speakers or analogue stereo outputs.

•Some DTS decoders which do not support DVD-DTS interface may not work properly with the unit.

17