38
Troubleshooting (Continued) Symptom Cause Correction
The DVD+VCR does not
start playback.
•An unplayable disc is inserted. •Insert a playable disc. (Check the disc
type and Regional code.)
•The disc is placed upside down. •Place the disc with the playback side
down.
•The disc is not placed within the guide. •Place the disc on the disc tray correctly
inside the guide.
•The disc is dirty. •Clean the disc.
•The Rating level is set. •Cancel the Rating function or change
the rating level.
Video tape cannot be
inserted.
•Is the cassette compartment empty? •Eject the tape in.
No Hi-Fi sound •Audio mode is not set properly. •Select STEREO by repeatedly pressing
AUDIO on the remote control.
No NICAM sound
recording
•NICAM mode is not set properly. •Make sure NICAM in the menu is set to
AUTO for the station to be recorded.
The remote control does
not work properly.
•There is an obstacle in the path of the
remote control and this unit.
•Remove the obstacle.
•The batteries in the remote control are
exhausted.
•Replace the batteries with new ones.
•The remote control is not pointed at the
remote sensor of the DVD+VCR.
•Point the remote control at the remote
sensor of the DVD+VCR.
•The remote control is too far from the
DVD+VCR.
•Operate the remote control within 23ft
(7 m).
•This remote control use the same buttons
for VCR and DVD functions (ex.PLAY).
•When using a VCR, first press the VCR
button. When using a DVD, first press
the DVD button.
Timer recording is not
possible.
•Clock in DVD+VCR is not set to correct
time.
•Set clock to correct time.
•Timer has been programmed incorrectly. •Reprogram Timer.
• indicator light does not appear after
programming timer.
•Reprogram Timer and turn DVD+VCR
off to enable timer.
VJ9033CP1Z_E-EZ.book Page 38 Friday, March 11, 2005 10:12 AM